gdsfactory.routing.get_route

gdsfactory.routing.get_route(input_port: Port, output_port: Port, bend: ComponentSpec = <function bend_euler>, with_sbend: bool = False, straight: ComponentSpec = <function straight>, taper: ComponentSpec | None = None, start_straight_length: float | None = None, end_straight_length: float | None = None, min_straight_length: float = 0.01, auto_widen: bool = False, auto_widen_minimum_length: float = 100, taper_length: float = 10, width_wide: float = 2, cross_section: None | CrossSectionSpec | MultiCrossSectionAngleSpec = 'xs_sc', **kwargs) → Route

Returns a Manhattan Route between 2 ports.

The references are straights, bends and tapers. get_route is an automatic version of get_route_from_steps.

Parameters:

• input_port – start port.

• output_port – end port.

• bend – bend spec.

• with_sbend – add sbend in case there are routing errors.

• straight – straight spec.

• taper – taper spec.

• start_straight_length – length of starting straight.

• end_straight_length – length of end straight.

• min_straight_length – min length of straight for any intermediate segment.

• auto_widen – auto widen the straights.

• auto_widen_minimum_length – minimum length to auto widen.

• taper_length – length of taper.

• width_wide – width of the wider straight.

• cross_section – spec.

• kwargs – cross_section settings.

import gdsfactory as gf

c = gf.Component('sample_connect')
mmi1 = c << gf.components.mmi1x2()
mmi2 = c << gf.components.mmi1x2()
mmi2.move((40, 20))
route = gf.routing.get_route(mmi1.ports["o2"], mmi2.ports["o1"], radius=5)
c.add(route.references)
c.plot()

(Source code, png, hires.png, pdf)