gdsfactory.cross_section.strip_heater_metal_undercut#
- gdsfactory.cross_section.strip_heater_metal_undercut(width: float = 0.5, layer: LayerSpec = 'WG', heater_width: float = 2.5, trench_width: float = 6.5, trench_gap: float = 2.0, layer_heater: LayerSpec = 'HEATER', layer_trench: LayerSpec = 'DEEPTRENCH', sections: tuple[Section, ...] | None = None, **kwargs) CrossSection [source]#
Returns strip cross_section with top metal and undercut trenches on both.
sides.
dimensions from https://doi.org/10.1364/OE.18.020298
- Parameters:
width – waveguide width.
layer – waveguide layer.
heater_width – of metal heater.
trench_width – in um.
trench_gap – from waveguide edge to trench edge.
layer_heater – heater layer.
layer_trench – tench layer.
sections – cross_section sections.
kwargs – cross_section settings.
|<-------heater_width--------->| ______________________________ | | | layer_heater | |______________________________| |<------width------>| ____________________ trench_gap | |<----------->| | | | | undercut | | width | | | | | |<------------>| |___________________| | trench_width | | | | |
import gdsfactory as gf xs = gf.cross_section.strip_heater_metal_undercut(width=0.5, heater_width=2, trench_width=4, trench_gap=4) p = gf.path.arc(radius=10, angle=45) c = p.extrude(xs) c.plot()
(
Source code
,png
,hires.png
,pdf
)